81
Barcode Handy Terminal
U the communication environment settings
1.
The SET COMMUNIC menu screen displays as shown on the
r
2. U ] [▼]) or numeric key to
highlight the item to be set and press the ENT key.
“1: O
C frared comm ters
“2: CONNECTOR”:
Changes the setting of the USB communication p
“3: COM PORT”:
port setting.
“ E”:
C mmunication
“5: OPEN “COM:” DETAIL”:
Changes the communication condition setting f ra the
BHT-BASIC.
Refer to the following section for details of the above items.
Press the Backspace/clear key to return to the SYSTEM MENU.
“1: OPTICAL”: Infrared communication parameters
1. Select “1: OPTICAL” at the SET COMMUNICATION menu and
then press the ENT key.
The SET OPTICAL menu screen displays as shown on the right.
2. Use the cursor keys ([▲] [▼]) or numeric keys ([1] [2]) to highlight
“1: PARAMETER” or “2: PROTOCOL”, and then press the ENT
key.
Press the Backspace/clear key to return to the SET SYSTEM menu.
“1: PARAMETER”: Setting the communication parameters
Select “1: PARAMETER” to display the screen shown on the right.
The highlighted setting will be the current setting.
“1: TRANSMIT SPEED”: Setting the transmission speed
To change the setting, use the highlight the transmission speed with
the cursor keys ([◄] [►]) and press the ENT key.
Press the Backspace/clear key to return to the SET OPTICAL menu.
se the following procedure if necessary to change
Select “5: COMMUNICATION” at the SET
then press the ENT key.
SYSTEM menu and
ATION
ight.
se the cursor keys ([▲ s ([1] [2] [3] [4])
PTICAL”:
hanges the in unication parame .
arameters.
Changes the communication
4: PROTOCOL TYP
hanges the co protocol setting.
or the user prog m (OPEN “COM:”) created via
To Next Page
Loading...
