- 11 -
E
1. Starter switch
The switch is 3-position switch which can be operated with its specific key only.
1) OFF
This switch should be set in this position unless the machine is in operation.
The key can be inserted or pulled out in this position.
2) RUN
This switch should be set in this position when the machine is in operation. In
this position, the preheating system is energized. When the preheat indicator
lamp lights up, reaching the set temperature, it goes off.
Then, turn the key to START.
3) START
This is the position to start the engine. When your hand is released from the
key after starting, it is automatically set in the position of “RUN”.
2.Local-remote change-over switch (in the control box)
1) REMOTE
This switch should be set in this position when machine starts with an external
device.
2) LOCAL
This switch should be set in this position when machine starts with the starter
switch.
3. Emergency stop button
The stop button is a push button to stop the engine in case of an emergency.
When the button is pressed, it must be unlocked by turning it anti-clockwise
before the engine can be re-started.
To Next Page
Loading...
