- 4 -
DANGER: ELECTRIC SHOCK can kill.
Do not touch the output terminals during operation to prevent decease due to electric shock.
• Never touch the output terminals during operation. If your hands or the machine are wet, it will result in
a death or serious injury.
• When a wiring work is required, be sure to turn OFF the circuit breaker and stop the machine.
• Keep the output terminal cover closed and the terminal bolts tightened while the machine is running.
• A low voltage is generated even when the machine is in low speed idle operation. Be sure to stop the
machine completely.
Do not touch the electrical parts in the machine during operation, as it may lead to death due to electric
shock.
• Always close the control panel and tighten the fixing bolts before operating the machine.
• Always close the side door and lock it before operating the machine.
• When opening the control panel for voltage selection, etc., turn OFF the circuit breaker and stop the
machine.
DANGER:
ELECTRIC SHOCK
by leak can kill.
CAUTION:
MOVING PARTS can
cause severe injury.
Improper grounding may lead to death due to
electric shock.
• Be sure to execute the grounding of the machine
and the load according to the local rule.
Rotary unit which runs at a high speed is located in
the machine. (Note that it is very dangerous if you
touch it.)
• Be sure to close the door and lock it during
operation.
• When the door needs to be opened during op-
eration, do not get your hands and head in the
machine to prevent them from being caught in
the machine which may lead to injury.
• When making check or maintenance of the ma-
chine, be sure to stop the machine in advance.
To Next Page
Loading...
Need help?
General
