Depa DH40-FA - Page 5

5
DEPA
®
Air Operated Diaphragm Pumps
imSinnederRichtlinie2014/34/EUfürGerätezurbestimmungsgemäßenVerwendung
inexplosionsgefährdetenBereichen
The manufacturer Crane Process Flow Technologies GmbH,
Heerdter Lohweg 63-71, 40549 Düsseldorf, www.depapumps.com
declares that the pump units manufactured in series production
Designation: DEPA air operated diaphragm pumps* and DEPA active pulsa-
tion dampeners
 *onlyappliestopumpswithinternalvalveandexternalsole-
noid air valve
Series
: DL, DH, DF, DZ, DJ, DP and PD, PH
Assessment method: Equipment group I, category M2
Pump size: 15, 25, 40, 50, 80
Casing material: CX, SX, PL, TL, SS, SFS, TPL, HS, HX
Diaphragm materials: PTFE compound, EPDM, NBR, PTFE, NRS, FKM**, S4**,
EPDM grey**
** not for size 80
Valve ball materials: EPDM, NBR, PTFE, NRS, 316L, FKM, EPDM grey
Accessories
: Needlevalve,levelcontrol,mobileunitvehicle,uidisation
system, collecting pan, suction lance, high-performance si-
lencer, ball lifter, suction and pressure hose
Installed electrical components
: Specicmanufacturer’sdeclarationsofconformityaresup-
plied with all of the electrical units
in the design delivered by us, are in compliance with the following applicable regulations:
EU Directive
: Directive 2014/34/EU for equipment authorised for use in po-
tentiallyexplosiveenvironments.
Harmonised standards
: DIN EN 1127-1:2008-02 (for pump and pulsation dampeners)
EN 13463-1:2009-07 (for accessories)
EN 13463-5:2011-10 (for accessories)
Mr. Ralf Rennwanz is authorised to compile the technical documents.
Crane Process Flow Technologies GmbH
Heerdter Lohweg 63-71
40549 Düsseldorf
Place / date: Düsseldorf, Germany, 17/06/2017
Signature of manufacturer:
Information on signatory
: Hans-Dieter Ptak, Managing Director
EU-Konformitätserklärung
ATEX
I M2