Det-Tronics UD10 - Table of Contents

APPLICATION ..............................1
DESCRIPTION ..............................1
HART Communication ......................3
Magnetic Switches ........................3
Relays ..................................4
4-20 mA Output Modes ......................4
Modbus / Fieldbus Compatibility ..............4
Device Enclosure .........................4
Device Display ...........................4
Logging .................................5
IMPORTANT SAFETY NOTES ...................5
INSTALLATION ..............................6
Identication of Vapor(s) to be Detected .........6
Identication of Detector Mounting Locations .....6
WIRING ....................................7
Power Supply Requirements .................7
Wiring Cable Requirements ..................7
Shield Connections .......................7
Jumper Setting for 4-20 mA Loop ............7
Foundation Fieldbus.......................7
Wiring Procedure ..........................8
STARTUP .................................12
TROUBLESHOOTING .......................15
SPECIFICATIONS ...........................18
DEVICE REPAIR AND RETURN ...............20
ORDERING INFORMATION ..................21
APPENDIX A — FM APPROVAL DESCRIPTION ....A-1
APPENDIX B — CSA CERTIFICATION DESCRIPTION . B-1
APPENDIX C — ATEX APPROVAL DESCRIPTION.....C-1
APPENDIX D — IEC APPROVAL DESCRIPTION ......D-1
APPENDIX E – UD10 WITH HANDHELD HART
COMMUNICATOR ...............................E-1
Wiring................................E-1
Menu Structure.........................E-1
APPENDIX F – UD10 WITH GT3000 TOXIC GAS
DETECTOR ....................................F-1
Wiring................................F-1
Orientation ............................F-2
Live Maintenance .......................F-2
Calibration ............................F-3
Menu Structure.........................F-4
APPENDIX G — UD10 WITH PIR9400 POINTWATCH ..G-1
Wiring................................G-1
Installation Notes .......................G-2
Orientation ............................G-2
Changing Operating Modes ...............G-3
Calibration ............................G-3
Menu Structure.........................G-4
APPENDIX H — UD10 WITH MODEL PIRECL ........H-1
Wiring................................H-1
Orientation ............................H-2
Calibration ............................H-3
Menu Structure.........................H-4
APPENDIX I — UD10 WITH OPEN PATH MODEL OPECL .....I-1
Wiring.................................I-1
Orientation .............................I-3
Calibration .............................I-3
OPECL Transmitter Lamp Fault Condition .....I-4
Menu Structure..........................I-4
APPENDIX J — UD10 WITH NTMOS H2S SENSOR ... J-1
Wiring................................ J-1
Installation Notes ....................... J-1
Orientation ............................ J-4
Calibration ............................ J-4
Menu Structure......................... J-5
APPENDIX K — UD10 WITH C706X TOXIC GAS SENSOR . K-1
Wiring................................K-1
Installation ............................K-3
Calibration ............................K-4
Menu Structure.........................K-4
APPENDIX L — UD10 WITH MODEL CGS SENSOR .....L-1
Wiring ................................L-1
Important Notes ........................L-1
Installation .............................L-3
Calibration .............................L-3
K-Factor. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . L-4
Menu Structure .........................L-4
APPENDIX M —
UD10 WITH MODEL 505/CGS . . . . . . . . .M-1
Wiring................................M-1
Installation ............................M-2
Orientation ............................M-2
Calibration ............................M-3
Menu Structure.........................M-4
APPENDIX N — UD10 WITH GENERIC 4-20 MA SENSOR . N-1
Operation .............................N-1
Menu Structure.........................N-1
Table of Contents