DEVA DB91-RX - How Should I Configure the Connection between My DEVA Device and an FTP Client; Appendix B

65 Aleksandar Stamboliyski Str., 8000 Bourgas, Bulgaria
Tel: +359 56 820027, Fax: +359 56 836700
E-mail: ofce@devabroadcast.com ,Web: www.devabroadcast.com
- 34 -
APPENDIX B
HOW SHOULD I CONFIGURE THE CONNECTION BETWEEN MY
DEVA DEVICE AND AN FTP CLIENT?
In order for a connection to be established the following setting should be applied:
1. FTP Server Settings
The built-in FTP Server has four important parameters that should be congured: Command
Port, Data Port, User name and Password. These parameters are to be used in the FTP client’s
connection conguration. Further information on how to change the FTP Server’s settings and
their respective default values can be found in the device’s User manual.
WE RECOMMEND the usage of FileZilla (https://lezilla-project.org). This is a widespread
open source software distributed free of charge, hence available for downloading from the Internet.
NOTE: The FTP Server can manage only one connection at a time. The FTP Server works in
Passive mode. Hence, the FTP Client should also be set in passive mode.
2. IP Router and Port Translation Settings
If the connection to the device is made through a Network address translation (NAT) router or
rewall, the port forwarding feature of the router should be congured. The port forwarding is
usually set in the rewall section of the router’s menu. As each router has different port forwarding
procedure, we recommend you to refer to its complete manual. To allow proper data ow through
the router, the FTP Command and FTP Data ports should be open.
NOTE: The FTP port numbers to be used in the port forwarding feature conguration can be
found in the device.