DeVilbiss AGMD Series - 3 Designs; Technical Data; High-Performance Automatic Spray Guns AGMD-514 and AGMD-515

High-performance automatic gun
AGMD
1-1-AGMD-514&515-E-002-1
9
3 Designs
The high-performance automatic spray gun AGMD is available in different designs. They
differ in the use of a variety of components and/or in the material flow.
Note!
Gun heads marked with a “U” have two material lines, allowing coating material to
circulate through the head so a colour change can be performed while the gun is
closed.
Ordering example: AGMD-514 U FF-797c
Type of gun
With circulation*
Nozzle size (see table)
Air cap (see table)
AGMD-514
U
FF
797c
* Without circulation= ″U″ does not apply
3.1 Technical data
3.1.1 High-performance automatic spray guns AGMD-514 and AGMD-515
Spray system: AGMD-514 conventional air-atomisation
AGMD-515 TransTech or HVLP air-atomisation
Maximum pressures: 0 to 14 bar material (MAT)
6 bar control air system (CYL)
9 bar atomiser air (ATOM) and horn air (FAN)
Switching times: < 60 msec. At 5.8 bar control air system
Weight: Approx. 665 g
Dimensions: Refer to dimensioned sketch
Materials: Gun head: Stainless steel 1.4305
Nozzle (standard): Stainless steel 1.4305
Paint needle (standard): Stainless steel 1.4305
Air distribution ring: Brass, chemically nickel-plated
Air cap: Brass, chemically nickel-plated
Air cap retaining ring: Brass, chemically nickel-plated
Material-contacting seals:
VITON for water-based coatings (on request)
VITON EX for solvent-based coatings (standard)
Perfluorelastomer for highest resistance (on request)
AGMD-514/515
with intermediate
plate AGMD-245-1