Page 3SB-2-855-B
EC Declaration of Conformity
We, Finishing Brands UK Ltd., Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as the manufacturer
of the Spray gun model SRi-PRO, declare, under our sole responsibility, that the equipment to which
this document relates is in conformity with the following standards or other normative documents:
BS EN 292-1 PARTS 1 & 2: 1991, BS EN 1953: 1999; and thereby conform to the protection
requirements of Council Directive 98/37/EEC relating to Machinery Safety Directive, and;
EN 13463-1:2001, council Directive 94/9/EC relating to Equipment and Protective Systems intended
for use in Potentially Explosive Atmospheres protection level II 2 G X. This product also complies with
the requirements of the EPA guidelines, PG6/34.
D. Smith, Vice President
1st May 2012
Operational Description
This SRi PRO Spray Gun is a professional quality gun designed with both high volume, low pressure (HVLP)
technology or Trans-Tech
®
technology. HVLP Technology reduces overspray and limits air cap pressure
to 0.7 bar (10 psi) (complies with rules issued by SCAQMD and other air quality authorities). Trans-Tech
technology, when tested under recommended conditions with automotive refinishing materials, has been
found to exceed 65% transfer efficiency.
IMPORTANT: These Sprayguns are suitable for use with both waterbased and solvent based coating
materials. These guns are not designed for use with highly corrosive and/or abrasive materials and if
used with such materials it must be expected that the need for cleaning and/or replacement of parts will
be increased. If there is any doubt regarding the suitability of a specific material, contact your DeVilbiss
Distributor or DeVilbiss direct.
NOTE: This gun is not to be used with halogenated hydrocarbon solvents or cleaning agents such as
1,1,1,-Trichloroethane or methylene chloride. These solvents can react with the aluminium components
used in this gun and cup. The reaction can become violent and lead to an equipment explosion.
Finishing Brands UK Ltd. reserve the right to modify equipment specification without prior notice.
To Next Page
Loading...
