Initial use 20
devolo Magic 1 LAN
1-1
3.3 Connecting the
devolo Magic 1 LAN
1-1
CAUTION! Damage to the device caused
by ambient conditions
Only use device indoors in dry conditions
In the following sections we describe how to
connect the devolo Magic 1 LAN
1-1
and integrate
it into a network. We clarify the exact procedures
based on potential network scenarios.
For the permitted voltage range for operating the device
and the power consumption, refer to the type plate on the
rear of the device. For additional technical information on
our products, refer to the product area at
www.devolo.com
.
3.3.1Starter Kit – Automatic set-up for a
new devolo Magic network
1 Connect one devolo Magic 1 LAN
1-1
to your
Internet access device's network connection
(e.g. your Internet router).
2 Connect the other devolo Magic 1 LAN
1-1
to
the network connection of your computer or
another network device using a network cable.
CAUTION! Tripping hazard
Lay the network cable in a barrier-free
manner and ensure that the electrical
socket and the connected network de-
vices are easily accessible
3 Plug both devolo Magic adapters into available
power sockets within 3 minutes. As soon as the
LEDs on both adapters flash white at regular
intervals of 0.5 sec., they are ready to operate
and automatically start the process of establis-
hing an encrypted connection to each other
(see Chapter 2.3.1 Reading the indicator
light).
If the LEDs on both devolo Magic adapters
light up in white, then your
devolo Magic network has been set up ac-
cording to your individual specifications
and is protected from unauthorised access.
To Next Page
Loading...
Need help?
General
