27 Configuration
devolo Magic 1 LAN
1-1
In order to use a new devolo Magic 1 LAN
1-1
in
your devolo Magic network, first you have to
connect it to your existing devolo Magic adapters
devices as a network. This is accomplished by using
a shared password. This can be assigned in diffe-
rent ways:
b Using devolo Cockpit or the
devolo Home Network App (see Chapter 3.4
Installation of devolo software),
b Only using the PLC/reset button (see Chapter
2.3 Pairing and 3.3 Connecting the
devolo Magic 1 LAN
1-1
)
b Using the web interface, in the PLC menu; as
described below:
Pairing – Using physical button and on-screen
button
1 First, press the PLC/reset button on a
devolo Magic adapter in your existing network.
2 Then, click PAIR to start the pairing operation.
This may take some time.
As soon as the new devolo Magic adapter is inte-
grated into your existing network, it appears in a
list of available and established connections (see
Chapter PLC connections).
Pairing – Using custom password
You can also assign your network a custom PLC
password you pick yourself. Enter this password for
each devolo Magic adapter in the PLC password
field and confirm your entry with OK.
Note that the custom password is not assigned
to the whole PLC network automatically. In-
stead, you must assign it separately to each of
your devolo Magic adapters.
Unpairing – Resetting or removing an adapter
from a network
1 To remove a devolo Magic adapter from your
devolo Magic network, click Unpair.
2 Wait until the LED flashes red and then dis-
connect the devolo Magic adapter from the
mains supply.
To Next Page
Loading...
Need help?
General
