SAFETY
-
IMPORTANT DO'S
AND
DON'TS
For
your
own
safety
and
efficient
use of
your DeWalt Powershop. follow these instructions carefully.
DO
Ensure
that
the
machine
is
properly connected
to
1.
the
mains
via a
13
amp
fused plug (240v)
or
permanently wired
in
(415v).
Be
sure that
the
earth wire
is
firmly
connected
to 2.
the
earth terminal
in the
plug.
Always disconnect your machine from
the
power
3.
supply before changing
any
attachments
or
accessories.
DO
NOT
Never connect
the
machine
up to any
voltage
other
than
that stated
on the
motor rating plate.
Never switch
on the
machine without
the
correct
guards being properly mounted.
Never switch
on the
machine
unless
all
clamping
handles
are
tightened.
4.
Ensure
all
guards
are
correctly positioned
and all
clamping
handles
are
tightened before starting
'
the
machine.
5.
Always wear close-fitting clothing without
loose ends. Remove loose-fitting ornaments
and
ties,
and
ensure long hair
is
secured
or
closely
covered.
6.
Wear protective
eye
shields.
7.
Make sure
the
sides
of the
blade
and the
arbor
collars
or
flanges
are
clean
and
that
the
recessed
sides
of the
collars
are
against
the
blade.
8.
Make sure
the
arbor
nut is
securely tightened
using both
the
alien
key and
spanner provided.
4.
Do not
allow spectators (especially children)
within
the
vicinity
of the
machine
while
working
with
it.
5.
Do not
leave
the
machine plugged into
the
mains while unattended.
6.
Never
use
blades larger
in
diameter than that
supplied
as
standard equipment (250mm).
7.
Never
rip
without
the
riving knife
and
anti-kickback
fingers correctly adjusted.
Never feed
in
material from
the
wrong side when
ripping
-
follow
the
instruction label
on the top of
the
arm.
9.
Before switching
on to
make
a
cut, make
sure that
the
fence
is in the
correct
position.
The
blade should
not
contact
the
material
until
you
pull-the
saw
carriage
forward.
9.
Never attempt
to oil or
grease
the arm
tracks
or
motor.
10.
Keep
saw
blades sharp
and
properly set.
10.
Never wedge anything against
the
motor
fan to
hold
the
motor shaft
still.
11.
When ripping always
use the
riving knife
and
anti-kickback
fingers
in
their
correct positions.
12.
Keep
the
bearing tracks
in the arm and the
bearings
on the
roller head assembly clean
and
dry and
free from grease.
13.
Periodically
check
the
machine's adjustments
to
ensure accurate woodworking
and
readjust
in
the
recommended sequence
if
necessary.
11.
Never feed
the
material into
the
blade faster than
it
will
cut it
comfortably.
12.
Do not
lift
the
Powershop
by its
worktable.
14.
Keep your
saw in a dry
place.
To Next Page
Loading...
