7
8514-311-001 REV PR
INFORMATION
A small diameter duct will restrict airflow;
a large diameter duct will reduce air
velocity - both contributing to lint build
up. An inspection door should be
provided for periodic clean out of the
main duct.
INFORMATION
STATIC BACK PRESSURE should be a
maximum of 7.6 mm w.c. (0.3-inch w.c.)
at the rear exhaust outlet of the dryer. If
multiple dryers are connected to the
common duct, ensure the back draft
damper is installed properly.
INFORMATION
THIS DRYER IS EQUIPPED WITH AN
OVER-TEMPERATURE THERMOSTAT
located to the right of the motor on the
rear of the cabinet. If the dryer ceases to
operate, refer to your “Service Procedure
and Parts Data” book for instructions.
INFORMATION
An individual gas shutoff valve is required
for each dryer and must comply with EN
331
INFORMATION
LEAVE THE ELECTRICAL POWER TO THE
DRYER ON AT ALL TIMES except when
necessary for service or other similar
activities. The hour meter function adds
only full hours to its reading. If the power
is shut off every night, any fraction of an
hour of time that is on the machine at
that time will be lost. Turning the power
off every night could also have some
effect on the long-term life of the
memory after a number of years. Turning
power off occasionally won’t affect the
unit.
INFORMATION
A DRYER SHOULD BE CONNECTED TO
POWER FOR THREE (3) MINUTES before
it is operated or before a program change
is made. Operation or program changes,
which occur during this "power up"
period, are subject to loss in case of
power interruption. After the initial three
minutes, all programmed data is
protected from power interruptions of any
length and the customer's individual cycle
is protected up to 3 seconds. This is done
without batteries.
To Next Page
Loading...
Need help?
General
