Dexter Laundry WN0675 - Page 26

2.6 FLOOR LOAD DATA
Model
Dry Weight
Capacity
(lb [kg])
Extract
Speed
(RPM)
Extract G-
Force
Maximum
Static Load
(lb [kN])
Static Load
Pressure
(lb/sq ft
[kN/ sq m])
Total
Dynamic
Load (lb
[kN])
Dynamic
Load
Pressure
(lb/sq ft
[kN/ sq m])
Dynamic
Load
Frequency
(Hz)
Maximum
Vertical
Load (lb
]kN])
Maximum
Moment About
Washer Base
(ft*lbs [m-kN])
T-350 20 [9.1] 819 200 447 [2.0] 94 [4.5] 800 [3.6] 168 [8.0] 13.7 1203 [5.4] 1571 [2.1]
T-450 30 [13.6] 750 200 618 [2.7] 113 [5.4] 1200 [5.3] 220 [10.5] 12.5 1756 [7.8] 2631 [3.6]
T-650 40 [18.1] 750 200 882 [3.9] 134 [6.4] 1600 [7.1] 243 [11.6] 12.5 2384 [10.6] 3508 [4.8]
T-750 50 [22.7] 685 200 1119 [5.0] 166 [7.9] 2000 [8.9] 297 [14.2] 11.4 2970 [13.2] 4667 [6.3]
T-950 60 [27.2] 685 200 1206 [5.4] 150 [7.2] 2400 [10.7] 299 [14.3] 11.4 3460 [15.4] 5600 [7.6]
T-1450 90 [40.8] 617 200 1635 [7.3] 163 [7.8] 3600 [16.0] 360 [17.2] 10.3 5012 [22.3] 9413 [12.8]
T-675 40 [18.1] 993 350 882 [3.9] 134 [6.4] 1600 [7.1] 243 [11.6] 16.6 2384 [10.6] 3508 [4.8]
T-975
60 [27.2] 969 400
1206 [5.4] 150 [7.2] 2400 [10.7] 299 [14.3]
16.2 3460 [15.4] 5600 [7.6]
T-1475 90 [40.8] 816 350 1635 [7.3] 163 [7.8] 3600 [16.0] 360 [17.2] 13.6 5012 [22.3] 9413 [12.8]
Note:
DEXTER DYNAMIC LOADING CHART
The out-of-balance loading conditions may very dependent on load size and
material.
Express Plus Washers
Express Washers
Plumbing
Water supply hoses are provided with each machine. The threaded connections on the hoses are ¾-11
½ NHT for 60 Hz models and ¾-14 BSP for 50 Hz models. Separate hot and cold water lines must be
supplied to the machine, maintaining 30 psi to 120 psi (207 kPa to 827 kPa) water ow pressure. A 140°F
(60°C) hot water supply is recommended for best washing results. Do not exceed 180°F (82°C) water
temperature.
Drain
The drain outlet tube size: T-650, T-750, T-950, and T-1450 is 3 inches (76 mm) in diameter.
Any drain hose used must be lower than the drain valve to assure proper draining.
Protective Film
The machine may have protective adhesive lm on the front escutcheon area and the front and side
stainless steel panels. The lm may be peeled o󰀨 before putting the machine into service.
26
Part # 8533-126-001 11/21