37
2
Hardware Installation
5. Run the Award BIOS setup utility to select the DRAM's voltage
in the "DRAM Voltage Control" field of the Genie BIOS Setting
submenu.
When the jumper is at pins 1 and 2 (default) the options in the
"DRAM Voltage Control" field is up to 3.1V. However, when it is
set at 2-3, additional options from 3.2V to 4V are available.
Make sure you have selected a CPU voltage other than Auto
(refer to step 1) otherwise the additional voltages will not
appear.
To Next Page
Loading...
