DFRobot OverLord 3D - Page 28

OverLord 3D Printer User Manual
28
(3) Select “Print” in the
control panel to enter print file
chosen menu.
Attention: If there is an unfinished print task, OverLord will remind you if you want to
continue that task. Choose “Yes” to continue and “No” to give up and then enter print file
chosen menu.
(3) Select the print file.
(4) Press “OK”,
OverLord starts printing.
Press“↑”or“↓”to select, press
“OK” to enter or confirm.
Yes：Continue last unfinished task.
No：Start new print