OverLord 3D Printer User Manual
(5) After heating
complete, OverLord start
to print automatically. A
printing progress bar and
estimated time will be
shown on screen.
During printing, if there
is a demand, you can
pause the printing at
any time by select
“Pause”.
CAUTION:
*During the operation of 3D Printer, if any accident happens, please stop the
machine by turning off the power switch.
*During printing, select “Tune” to enter Tune menu.
Return to the printing status interface
Printing speed, 100% by default. Adjust it by pressing “↑” or “↓”.
Temperature of nozzle. It should set to different default values according to
different materials. Adjust it by pressing “↑” or “↓”.
Temperature of buildplate. It should set to different default values according to
different materials. Adjust it by pressing “↑” or “↓”.
Fan speed is set to 100% as default. Adjust it by pressing “↑” or “↓”.
Material extrude rate, by default 100%. Adjust it by pressing “↑” or “↓”.
*During printing, you can select “Pause” to pause the printing. Once selected, the printer will
save printing progress data, and the screen shows “Waiting”. The saving finishes when
“Waiting” disappear. Next time when you enter print file menu again (it doesn’t matter
whether you have turned off the printer or not), OverLord will remind you do you want to
continue the unfinished task last time. Press “OK” to confirm.
(6) When the print is done,
nozzle returns to its home
position. Please wait until
the nozzle temperature and
buildplate temperature
drop down to room
temperature.
To Next Page
Loading...