DGSHAPE DE-3 - Important Notes on Handling and Use

This machine is a precision device. To ensure the full performance of this machine, be sure to
observe the following important points. Failure to observe these points may not only result in loss
of performance but may also cause malfunction or breakdown.
This machine is a precision device.
• Handle this machine carefully and never subject it to impacts or excessive force.
• Carefully clean away cutting waste.
• Use this machine within the range of its specications.
• Never needlessly touch anywhere inside the machine except for locations specied in this manual.
Install this machine in a suitable location.
• Install this machine in a location that meets the specied conditions for temperature, humidity, and the like.
• Install this machine in a quiet, stable location oering good operating conditions.
• Never install this machine outside.
• Never use the machine in an environment where silicone substances (oil, grease, spray, etc.) are present.
Doing so may cause poor switch contact.
This machine becomes hot.
• Never cover the ventilation holes with cloth, tape, or anything else.
• Install this machine in a well-ventilated location.
About tools
• Use an appropriate tool that matches the workpiece and the engraving method.
• The tip of the tool is breakable. Handle the tool with care, being careful not to drop it.
Important Notes on Handling and Use
15