DGSHAPE DE-3 - Pausing and Aborting Engraving

Installation Space
Ensure that at least the following amount of space is available.
Work space
1.0 m
2.0 m
(6.6 ft.)
2.0 m (6.6 ft.)
1.0 m
Installation space
Installation Location Height
The installation location should be above the work oor by 0.6 m (23.6 in.) or more.
This machine is a desktop-type unit. Install this machine in a position so that you can easily reach the emergency
stop button when operating this machine.
Removing the Retainers
Retainer is attached to the machine to protect it from vibration during shipment. When installation is complete,
remove these retainers.
• Remove all the retainers. Any that remain may cause faulty operation or a breakdown when the power is
switched on.
• The retainer will be required when moving the machine to a dierent location. Store them carefully so that
they do not get misplaced.
WARNING
Carry out these operations before you connect the power cord.
The power turning on inadvertently during these operations may result in pinched
hands or other injury.
WARNING
Be sure to perform operations as specied by these instructions, and never
touch any area not specied in the instructions.
The machine may move in an unexpected way, resulting in injury or burns.
Installation
19