DGSHAPE DE-3 - Before Starting Operations; Performing Spindle Run-In (Warm-Up)

Performing Spindle Run-in (Warm-up)
Perform run-in to stabilize the rotation of the spindle. This operation manually starts and stops rotation of the
spindle. You perform the operation using the handy panel.
Procedure
A
Close the front cover.
B
Press [ENTER/PAUSE].
C
On the main screen, press [SPINDLE].
The cursor moves to [S], and the spindle rotating speed can be changed.
SPINDLE
ON/OFF
Before Starting Operations
38