DGSHAPE DE-3 - Page 41

D
Turn the [Dial] on the handy panel until the spindle rotating speed reaches "5000 rpm."
Slow
Fast
X 50.00mm
Y 30.00mm
Z 20.00mm S 5000rpm
012345678901234567 READY
Spindle rotating speed
CAUTION
The spindle rotating speed can only be changed while the cursor is displayed at the [S] position.
X 50.00mm
Y 30.00mm
Z 20.00mm S 5000rpm
012345678901234567 READY
If no operations are performed for a certain amount of time and the cursor disappears, press [SPINDLE] several
times to move the cursor to [S], and then operate the [Dial].
E
Hold down [SPINDLE] for one second or longer.
The spindle begins to rotate.
F
Leave the spindle rotating for 15 minutes.
G
Press [SPINDLE].
Rotation of the spindle stops.
H
Repeat steps
C
to
G
under the following conditions:
Number of rotations Working time
Second time
10,000 rpm 10 minutes
Third time
15,000 rpm 10 minutes
Fourth time
20,000 rpm 15 minutes
Important: This operation cannot be performed in the following situations.
• When the machine is performing some operation
• When the front cover is open
Before Starting Operations
39