• To ensure safe use with a full understanding of this machine's performance, please be sure to read through this
manual completely.
• Store this manual in a safe place where it can be referred to when needed.
• Reproduction, citation, or translation, in whole or in part, of this manual is prohibited without the express written
consent of DGSHAPE Corporation.
• The contents of this operation manual and the specications of this product are subject to change without notice.
• DGSHAPE Corporation assumes no responsibility for any damage that may occur through use of this product,
regardless of any failure to perform on the part of this product or of any errors in this document. Damage includes
but is not limited to damage caused by the specications or performance of the product, damage caused by non-
use of the product, and damage caused by deliverables obtained through use of this product. Such damage can
be either direct or indirect.
Applicable EMC Standards: EN 61326-1 (Class A), EN 55011 (Class A, Group 1)
This product is a Class A device.
It may generate radio wave interference when used in a residential environment. In this situation,
the user may be required to implement appropriate countermeasures.
This product is a Group 1 device.
Radio frequency energies in the form of electromagnetic radiation, induction, and/or electrostatic
bonding are not used nor deliberately emitted when processing material or during examination/analysis.
This system (including the housing and safety device) is a Class 1 laser product.
Complies with IEC 60825-1 Edition 2.0 (2007-03).
Complies with FDA performance standards for laser products except for deviations pursuant to Laser
notice No.50 dated June 24, 2007.
Caution - Use of controls or adjustments or performance of procedures other than those specied herein
may result in radiation exposure.
To Next Page
Loading...
