DH Instruments PPC2 AF - 1 I N S T al L at I O N an D S H O R T T E R M S T O R Ag; Unpacking and Inspection; Removing from Packaging; Inspecting Contents

2. INSTALLATION AND SHORT TERM STORAGE
Page 11 © 1998 DH Instruments, Inc.
2
2
.
.
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
A
A
N
N
D
D
S
S
H
H
O
O
R
R
T
T
T
T
E
E
R
R
M
M
S
S
T
T
O
O
R
R
A
A
G
G
E
E
2.1 UNPACKING AND INSPECTION
2.1.1 REMOVING FROM PACKAGING
PPC2 AF is delivered in a molded medium density polyethylene shipping case with a custom
foam insert for holding the PPC2 AF, SPLT if included, documentation and accessories.
Remove all PPC2 AF elements from the shipping case and remove each element from its
protective plastic bag.
2.1.2 INSPECTING CONTENTS
Check that all items are present and have no visible damage.
PPC2 AF includes:
DESCRIPTION PART NO.
PPC2 AF Pressure Controller/Calibrator 401270
Calibration Certificate 550200
Test Report 550102
ACCESSORIES: 401273
User’s Manual 550090
Power Cord (7.5 ft.) 100770
(4) Rubber Feet Caps 400202
1/4 in. NPT Male X KF 16 SS Vacuum Adaptor 102519
Male Electrical Connector for Drivers 102478
SPLT on Stand (with filter) * 401271
(1) Spare SPLT Filter Element * 102502
Shipping Case with Inserts 401272
* If supplied.
2.2 SITE REQUIREMENTS
The PPC2 AF can be installed on any flat, stable surface at a convenient height. The front feet can be
extended so that the unit can be inclined slightly for easier viewing. The PPC2 AF can also be mounted in
a standard 19" rack mount using the optional rack mount kit.
Minimizing the length of tubing between the PPC2 AF to the device or system to be tested will
enhance control performance and reduce pressure setting times.
Ready access to the PPC2 AF rear panel should be considered to facilitate making and breaking
pressure connections.
The SPLT, if used, needs to be mounted vertically at the low point of the pneumatic system.