PPC2 AF OPERATION AND MAINTENANCE MANUAL
© 1998 DH Instruments, Inc. Page 32
If the sequence was set up with "Next increment on timed delay", execution will
proceed automatically from increment to increment after a "ready" condition has
occurred at the increment and the countdown timer has expired. If the sequence
was set up with "Next increment on ENTER", ENTER must be pressed to
continue to the next increment.
Regardless of whether the sequence was set up for next increment on time
delay or on ENTER, pressing ENTER always causes the sequence to proceed
to the next increment. This feature can be used to skip one or several
increments if desired.
The display is:
Abort quick sequence
1Yes 2No
To interrupt the sequence, press ESCAPE or a direct pressure control key.
Pressure control will immediately cease and the display will go to:
Selecting 1Yes causes the sequence to abort and returns to the main run screen.
2No causes the sequence to resume where it left off.
All Quick Sequences end with a VENT command after the last point. To avoid
the VENT, ESCAPE after the last point.
To Next Page
Loading...