Diamondback 860Er - Maintenance

28
860 Er Owner’s Manual
Workout Programs (continued) / Maintenance
MAINTENANCE
CAUTION – FOR SAFE OPERATION
Always inspect hardware prior to any exercise session. Look for loose hardware, loose
pedals, loose handrails, loose cranks and frayed wires. Repair or replace any dam-
aged or worn parts, tighten all loose hardware.
After workout, always wipe down your 860Er unit. Perspiration that continuously set-
tles on frame, pads or casing may eventually cause rust or damage to the unit. Damage
resulting from lack of proper maintenance will not be covered under warranty. To clean
pads, use a mild soap and warm water. Dry with a clean towel.
If noises develop or malfunctions occur, contact your authorized Diamondback Fitness
dealer.
setting and adjust. Until the adjustment is done, it then will resume to display
actual HR. Dot matrix window will update the Work %Max HR profile
accordingly.
Ending the Program
• When selected program time is up or Stop key is pressed, this program will end
and Cool down will be active. See Cool down section for details.
• There will be a beep sound to indicate the program ended.
Pause, Reset, Re-start or Switch a program
See Console Operating Tips section for details, page 13.
860erOM 6/20/06 8:42 PM Page 30