11.3.4. Communications Password [ 7 3 4 ]
If this code is programmed it will have to be entered in order
to gain access to programming: 5 – Communications.
To program this code, do as follows:
1. Press MENU 2 seconds.
2. Press 7 3 4.
3. The scale will display the message: “Enter new
communications code”. Type in the 4-digit code.
4. Repeat the code and will display OK.
5. Press MENU 2 seconds to quit the programming menu.
11.3.5. Lists Password [ 7 3 5 ]
If this code is programmed it Hill have to be entered in order
to gain access to programming: 8- Reports, 9- Deleted.
To program this code, do as follows:
1. Press MENU 2 seconds.
2. Press 7 3 5.
3. The scale will display the message to introduce the ney
key. Type in the 4-digit code.
4. Repeat the code and will display OK.
5. Press MENU 2 seconds to quit the programming menu.
11.4. PRINTING PARAMETERS [ 7 4 ]
With this type of programming you can lay down the different
criteria by which the scale will print the information.
11.4.1.Label parameters [ 7 4 1 ]
Here the parameters used for printing the labels are
established. The process is as follows:
1. Press MENU 2 seconds.
2. Press 7 4 1.
The label parameters are:
11.4.1.1.Label Way Out [ 7 4 1 1 ]
With this parameter you can adjust the printout of the label
so that on printing, it does not remain inside the printer and
can be easily removed. To change the value of this
parameter:
Enter the printout distance as a number between 0 and 100
(in general, between 50 and 60 is an acceptable value.
Press ∗
∗∗
∗ to save and go on to program contrast or press
Menu 2 seconds to quit the programming menu.
To Next Page
Loading...
