5.1.2.5. Multiplication
[ 3 2 5 ]
This option is used to determine if the scale can carry out
multiplication operations in normal working mode.
‘YES’ – It enables multiplication. (Default value)
‘NO’ – It does not enable multiplication.
‘FORCE UNIT’ – Permits multiplication. Units must be entered
in all article sales that are classified as UNIT type.
5.1.2.6. Subtraction
[ 3 2 6 ]
Just like the previous parameter but for subtraction operations.
(The – key)
‘YES’ – It enables subtraction. (Default value)
‘NO’ – It does not enable subtraction.
5.1.2.7. Addition
[ 3 2 7 ]
Just like the previous parameter but for addition operations. (The
+ key)
‘YES’ – It enables addition. (Default value)
‘NO’ – It does not enable addition.
5.1.2.8. Subtotal
[ 3 2 8 ]
It allows you to configure the ◊
◊◊
◊ (subtotal) key. You can enter one
of the following values:
‘0’ – The ◊
◊◊
◊ key is enabled for subtotal operations. On pressing
◊
◊◊
◊ the subtotal appears on the visual display and, on pressing
the + and – keys, you can review the receipt line by line.
‘1’ – The ◊
◊◊
◊ key is disabled for any subtotal operation.
‘2’ – The ◊
◊◊
◊ key is enabled for both subtotal and provisional
subtotal. Whenever an operation is stored, the subtotal is
shown for four seconds (temporary subtotal). Moreover, on
pressing the ◊
◊◊
◊ and the memory key corresponding to the sales
assistant, the subtotal shows up on the visual display, and, on
pressing the + and – keys, the receipt can be reviewed line by
line.
‘3’ – Only provisional subtotal operations are carried out.
5.1.3.Receipt configuration [ 3 3 ]
This programming allows to define all the parameters related to
the receipt data and printing
To enter in this menu press MENU for 2 seconds and then 3 3.
Press
∗
∗∗
∗
The access to the submenus it is possible by pressing the key
∗
∗∗
∗
or by entering directly the code of the submenu after pressing
MENU.
Change from one option to another by using F2 to go down the
menu and F1 to go up.
To exit Configuration programming, press MENU
To Next Page
Loading...
