11.4.1.14. Distance Opto Thermal Head [ 7 4
1 14 ]
By varying the value of this parameter you can centre the
printing field of the labels in a vertical sense both upwards
and downwards achieving greater efficacy than with the
previous CENTRE LABEL parameter.
You can enter a value between 0 and 99 (by default 32).
Press ∗
∗∗
∗ to save and move on to program label paper
collector or press MENU 2 seconds to quit the programming
menu.
11.4.1.15. Backing Paper Rewinder [ 7 4 1
15 ]
This parameter controls the label paper collector.
‘YES’ – Label paper is collected.
‘NO’ – Label paper is not collected.
Press ∗
∗∗
∗ to save and MENU 2 seconds to quit the
programming menu.
11.4.2.Receipt parameters [ 7 4 2 ]
With the aid of this type of programming the parameters to
be used when printing receipts are set. The programming
process is as follows:
1. Press MENU 2 seconds
2. Press 7 4 2
11.4.2.1.Label Contrast [ 7 4 1 2 ]
Not available.
11.4.2.2.Lines End of Receipt [ 7 4 2 1 ]
The value of this parameter indicates the number of free
lines to be left after the receipt is printed (from 0 up to 9
lines), to ensure all information included is visible in its
entirety.
The possible values are 0 to 9.
Press ∗
∗∗
∗ to save and move on to program the receipt format
or press MENU
2 seconds to quit the programming menu.
11.4.2.3.Receipt format [ 7 4 2 2 ]
With this parameter, whose value is between 0 and 2*,
decide in which format by default the receipts will be printed,
in such a way that if it is set at:
0 - 1 Pre-defined receipt.
2* Receipts programmable by the user.
To modify this parameter:
Enter the required value.
Press ∗
∗∗
∗ to save and move on to program the receipt
parameter on the label or press MENU 2 seconds to quit the
programming menu.
To Next Page
Loading...
