11.4.1.9.EAN Format of level 1 totals [ 7 4 1
9 ]
Here, the EAN format of the level 1 totals label is selected if
you wish to work with accumulated total labels for an article.
(See CONF. EANC01...EANC10)
If this parameter is set to 0, the format of the labelled article
will be printed. (See EAN-13 FORMAT)
Press ∗
∗∗
∗
to save and enter level 2 EAN programming, or
MENU 2 seconds to exit.
11.4.1.10. EAN Format of level 2 totals [ 7 4
1 10 ]
Here, the EAN format of the level 2 totals label is selected
If this parameter is set to 0, the format of the labelled article
will be printed. (See sect. EAN-13 FORMAT)
Press ∗
∗∗
∗ to save and enter level 3 EAN programming, or
MENU 2 seconds to exit the programming menu.
11.4.1.11. EAN Format of level 3 totals[ 7 4 1
11 ]
Here, the EAN format of the level 3 totals label is selected
If this parameter is set to 0, the format of the labelled article
will be printed. (See EAN-13 FORMAT)
Press ∗
∗∗
∗ to save and enter Centre label programming, or
MENU 2 seconds to exit the programming menu.
11.4.1.12. Centre Label [ 7 4 1 12 ]
By adjusting the value of this parameter, you can shift the
label’s printing field vertically downwards, with very little
variation. It can be programmed at a value between 0 and
40.
Press ∗
∗∗
∗ to save and move on to program thermal head
optimum distance or press MENU 2 seconds to quit the
programming menu.
11.4.1.13. Centre Receipt in the labeller [ 7 4
1 13 ]
Adjusting the value of this parameter is posible to shift the
beginning of the printing of the receipt. When it is printed in
the labeller. Is possible program a value from 0 to 40.
Pressing ∗
∗ ∗
∗ in order to save and programming the Termal
head optimun distance or press MENU till you leave the
configuration menu.
To Next Page
Loading...
