11.4.1.4.Heading [ 7 4 1 4 ]
This parameter affects the printing mode of both the labels
and the receipts, and can have a value of between 0 and 1
with the meanings:
‘0’ - No backward and does not print the header.
‘1’ - Backward and prints the header.
Enter the required value as a number from 0 to 1.
Press ∗
∗∗
∗ to save and move on to program Paper Type or
press MENU 2 seconds to quit the programming menu.
It varies the arrangement of the fields when you vary the
distance to vary the output distance. And the same label
programmed with or without backspace is printed differently.
11.4.1.5.Type of Paper [ 7 4 1 5 ]
With this parameter, you choose the type of paper with which
the label printer is going to work, that is:
‘0’ - Self-adhesive label paper.
‘1’ - Continuous paper without collector.
‘2’ - Continuous paper with collector.
‘3’ – Linerless (See linerless Appendix).
Linerless systems is only available in M-525
Press ∗
∗∗
∗
to save and move on to program the Level 1 Totals
Format or press MENU
2 seconds to quit the programming
menu.
11.4.1.6.Total format Level 1 [ 7 4 1 6 ]
The value of this parameter indicates the format with which
the level 1 total labels are to be printed. If the value is 0, the
format of the labels that have been issued will be used.
Press ∗
∗∗
∗ to save and enter Level 2 Totals Format
programming or press MENU 2 seconds to exit the
programming menu.
11.4.1.7.Total Format Level 2 [ 7 4 1 7 ]
The value of this parameter indicates the format with which
the level 2 total labels are to be printed. If the value is 0, the
format of the labels that have been issued will be used.
Press ∗
∗∗
∗ to save and enter Level 3 Totals Format
programming or press MENU 2 seconds to exit the
programming menu.
11.4.1.8.Total Format Level 3 [ 7 4 1 8 ]
The value of this parameter indicates the format with which
the level 3 total labels are to be printed. If the value is 0, the
format of the labels that have been issued will be used.
Press ∗
∗∗
∗ to save and enter EAN format of Level 1 Totals
programming or press MENU 2 seconds to exit the
programming menu.
To Next Page
Loading...
