Need help?Do you have a question about the DIEL AT200 and is the answer not in the manual?
Procedure to access the programming menu, indicated by the PRG message.
Setting for PTC sensors: 0 for Disabled, 1 for Enabled.
How to reset active alarms using specific key combinations.
Procedure to restore factory settings and reset alarms.
Automatic calibration for fan current consumption reference and alarm management.
Displays the initial SET value stored during calibration.
Shows the maximum overcurrent value that has been reached.
Displays the admitted current offset value.
Shows the time delay before alarm analysis after fans start.
Displays the duration of an error before an alarm is triggered.
Indicates whether PTC sensors are enabled or disabled.
Shows which channels are enabled during the programming phase.
Indicates current consumption exceeding the calibrated value.
Indicates current consumption below the calibrated value.
Signals an over-temperature fault in at least one fan motor.
Procedure to access the programming menu, indicated by the PRG message.
Setting for PTC sensors: 0 for Disabled, 1 for Enabled.
How to reset active alarms using specific key combinations.
Procedure to restore factory settings and reset alarms.
Automatic calibration for fan current consumption reference and alarm management.
Displays the initial SET value stored during calibration.
Shows the maximum overcurrent value that has been reached.
Displays the admitted current offset value.
Shows the time delay before alarm analysis after fans start.
Displays the duration of an error before an alarm is triggered.
Indicates whether PTC sensors are enabled or disabled.
Shows which channels are enabled during the programming phase.
Indicates current consumption exceeding the calibrated value.
Indicates current consumption below the calibrated value.
Signals an over-temperature fault in at least one fan motor.
General| Brand | DIEL |
|---|---|
| Model | AT200 |
| Category | Control Unit |
| Language | English |
To Next Page
