XBee® Wi-Fi RF Modules
© 2013 Digi International, Inc. 112
Europe (ETSI)
The XBee Wi-Fi RF Module has been certified for use in several European countries. For
a complete list, refer to
www.digi.com
If the module is incorporated into a product, the manufacturer must ensure compliance
of the final product to the European harmonized EMC and low-voltage/safety standards.
A Declaration of Conformity must be issued for each of these standards and kept on file
as described in Annex II of the R&TTE Directive.
Furthermore, the manufacturer must maintain a copy of the XBee user manual
documentation and ensure the final product does not exceed the specified power
ratings, antenna specifications, and/or installation requirements as specified in the user
manual. If any of these specifications are exceeded in the final product, a submission
must be made to a notified body for compliance testing to all required standards.
OEM Labeling Requirements
The 'CE' marking must be affixed to a visible location on the OEM product.
CE Labeling Requirements
The CE mark shall consist of the initials "CE" taking the following form:
• If the CE! alert marking is reduced or enlarged, the proportions given in the
above graduated drawing must be respected.
• The CE! alert marking must have a height of at least 5mm except where this is
not possible on account of the nature of the apparatus.
• The CE! alert marking must be affixed visibly, legibly, and indelibly.
To Next Page
Loading...
