Digi XBee Manual

XBee® Wi-Fi RF Modules
© 2013 Digi International, Inc. 58
PLATFORM_INFO (0x80):
When a PLATFORM_INFO_REQUEST command request has been unicast to a node, that
node will send a response in the following format to the source endpoint specified in
the requesting frame.
Field Name Command –Specific Description
GPM_CMD_ID
Should be set to PLATFORM_INFO (0x80).
GPM_OPTIONS
A 1 in the least significant bit indicates an error occurred. All
other bits are reserved at this time.
GPM_BLOCK_NUM
Indicates the number of GPM blocks available.
GPM_START_INDEX
Indicates the size of a GPM block in bytes.
GPM_NUM_BYTES
The number of bytes in the GPM_DATA field. For this command,
this field will be set to 0.
GPM_DATA
No data bytes should be specified for this command.
Example:
A PLATFORM_INFO_REQUEST sent to a radio with a serial number of
0x0013a200407402AC should be formatted as follows (spaces added to delineate
fields):
7E 001C 11 01 0013A200407402AC FFFE E6 E6 0023 C105 00 00 00 00 0000 0000 0000 24
Assuming all transmissions were successful, the following API packets would be output
the source node's serial interface:
7E 0007 8B 01 FFFE 00 00 00 76
7E 001A 91 0013A200407402AC FFFE E6 E6 0023 C105 C1 80 00 0077 0200 0000 EB
ERASE (0x01):
The ERASE command erases (writes all bits to binary 1) one or all of the GPM flash
blocks. The ERASE command can also be used to erase all blocks of the GPM by setting
the GPM_NUM_BYTES field to 0.
Field Name Command –Specific Description
GPM_CMD_ID
Should be set to ERASE (0x01).
GPM_OPTIONS
There are currently no options defined for the ERASE command.
Set this field to 0.
GPM_BLOCK_NUM
Set to the index of the GPM block that should be erased. When
erasing all GPM blocks, this field is ignored (set to 0).
GPM_START_INDEX
The ERASE command only works on complete GPM blocks. The
command cannot be used to erase part of a GPM block. For this
reason, GPM_START_INDEX is unused (set to 0).
GPM_NUM_BYTES
Setting GPM_NUM_BYTES to 0 has a special meaning. It indicates
that every flash block in the GPM should be erased (not just the
one specified with GPM_BLOCK_NUM). In all other cases, the
GPM_NUM_BYTES field should be set to the GPM flash block size.
GPM_DATA
No data bytes should be specified for this command.

Digi XBee Specifications

General

Operating Frequency	2.4 GHz
RF Data Rate	250 kbps
Model	XBee S2C
Category	Control Unit
Operating Voltage	2.1 to 3.6V DC
Operating Temperature	-40 to +85 °C
Interface	UART
Dimensions	24.38 x 27.61 x 9.14 mm