digicon CATRAX Plus - 7.2 Defects and Possible Causes

30
7.2 Defects and possible causes
Defect
Posible cause
Action
· CATRAX Plus will not
tun on
· The power supply cable is not connected
properly
· The fuse of the power supply is blown
· Check the cables and the
fuse (fuse: 3 A)
· CATRAX Plus locked · Optical sensors obstructed or defective · Perform the preventive
routine maintenance on the
sensors or forward the
equipment to the Technical
Assistance
· A CATRAX Plus does
not activate the
electromagnet
(turnstile cannot be
locked)
· The cable is broken or the distance
between the electromagnet and the
locking device is maladjusted
· Adjust the electromagnet or
forward the equipment to the
Technical Assistance
· The arm does not
remain in the correct
position
· There is wear, dirt, a broken spring or
lack of lubrication in the sphere base
· Request a replacement for
the faulty part or forward the
equipment to the Technical
Assistance
· CATRAX Fit does not
lock in the first tooth
· The distance between the electromagnet
and the locking device is maladjusted
· Adjust the electromagnet or
forward the equipment to the
Technical Assistance
plus