Digi 001 Quick Start Guide
40
Using Monitor Mode
The Monitor Mode feature allows you to monitor analog inputs 3–4 on the Digi 001 I/O
Box even when the power for your computer is off, or your Digi 001 I/O Box is
disconnected from the computer. You can use this to monitor a CD player, synth, or tape
machine without an external mixer, and without your computer on.
To use Monitor Mode:
1
Connect analog audio outputs of your device to analog inputs 3 and 4 on the back of the
Digi 001 I/O Box.
2
Connect speakers for monitoring audio to the Monitor outputs on the back of the
Digi 001 I/O Box (see “Monitoring Audio” on page 30 for connection information).
3
Press the Monitor Mode switch in.
4
Adjust the monitoring volume using the monitor volume knob.
Using Monitor Mode
connect powered speakers
or amplifier here
connect source
(CD player, synth,
tape deck) here
press Monitor
Mode switch in
use monitor volume knob
for volume control
To Next Page
Loading...
Need help?
General
