Chapter 2: Macintosh Configuration
5
chapter 2
Macintosh Configuration
Installing the Digi 001 Hardware
Before installing the Pro Tools LE software, first install the Digi 001 card.
To install the Digi 001 card in your Macintosh:
1
Turn off your computer. Leave it plugged in so that it is grounded.
2
Open the computer case. If necessary, refer to the manufacturer’s instructions for details.
3
Remove the rear slot cover and screw of any available PCI expansion slot.
4
Before handling the Digi 001 card, discharge any static electricity by touching the outer
casing of the power supply.
5
Remove the Digi 001 card from its anti-static bag.
6
Hold the card gently by the top edges, and line up its PCI connector with the PCI slot
inside the computer.
PCI card installation for Macintosh Blue & White G3
To Next Page
Loading...
Need help?
General
