Digi 001 Quick Start Guide66
6 Repeat this until you are able to achieve maximum signal level without clipping.
7 Adjust the gain on analog channels 3–8 by using Other Options in the Hardware Setup
dialog (Setups > Hardware, then click Other Options).
✽ Gain cannot be adjusted for digital inputs, unless you can adjust it at the
source.
Setting recording input levels (Aux Track on left, Disk Track on right)
Other Options dialog
try to set input peaks here
record-enabled
record-enabled
bright red light indicates clipping!
(white button,
red text)
(red fader)
No need to record
enable an aux track
input
try to set input peaks here
analog input gain 3–8
high-pass filters
To Next Page
Loading...
Need help?
General
