DigiDesign Mbox Basic Guide

Creating an Audio CD from a Pro Tools Session
13
7 Choose “Convert after Bounce,” and click
Bounce.
8 In the Bounce dialog, give the bounce tracks a
name and choose where they should be saved.
9 Click Save.
Pro Tools will begin bouncing to disk. Pro Tools
bounces are done in real time, so you hear audio
playback of your mix during the bounce process
(though you cannot adjust it).
.
Burning a CD
After the bounce is completed, you will have an
audio file that is ready for burning onto a CD.
Quit Pro Tools and launch any common third-
party CD burning application to burn your
bounced mix to CD.
Bounce options for creating CD burnable tracks
Save Bounce Dialog
Bouncing to Disk dialog
Make certain that you configure your CD
burning application to create an audio CD
rather than a data CD.
USO RESTRITO

DigiDesign Mbox Specifications

General

Type	Audio Interface
Mic Preamps	2
Phantom Power	Yes
Bit Depth	24-bit
Software Included	Pro Tools LE
Connectivity	USB
Simultaneous I/O	2 x 2
Analog Inputs	2 x XLR/TRS combo
Analog Outputs	2 (1/4" TRS)
Headphone Output	1 x 1/4" TRS
Sample Rate	48 kHz