DigiPos WD-2030 - Page 27

WD-2030 XXXX customer display
26
*REMARK
*1 Using commands “EOT SOH S n ETB”, the value (Hex) of parameter
n Layer
31h
Save data in layer 1
32h
Save data in layer 2
33h
Save data in layer 3
Table 8-10
*2 Using commands “EOT SOH D n m ETB”, the value (Hex) of parameter. WinPOS
extended “select mode” from 33h to 37h
n Select layer m Select mode
31h
Demo layer 1 31h
Demo mode 1
32h
Demo layer 2 32h
Demo mode 2
33h
Demo layer 3 33h
Demo mode 3
34h
Demo layer 1 + 2 34h
Demo mode 1 + 2
35h
Demo layer 1 + 3 35h
Demo mode 1 + 3
36h
Demo layer 2 + 3 36h
Demo mode 2 + 3
37h
Demo layer 1 + 2 + 3 37h
Demo mode 1 + 2 + 3
Table 8-11