Digisol DG-GS4900SE Series User Manual

DG-GS4900SE Series Installation Guide
17
2.1.2 Installation Notice

Read through the installation instruction carefully before operating on the system.
Make sure the installation materials and tools are prepared. And make sure the
installation site is well prepared.
 During the installation, users must use the brackets and screws provided in the
accessory kit. Users should use the proper tools to perform the installation. Users
should always wear antistatic uniform and ESD wrist straps. Users should use
standard cables and connecters.
 After the installation, users should clean the site. Before powering on the switch,
users should ensure the switch is well grounded. Users should maintain the switch
regularly to extend the lifespan of the switch.
2.1.3 Classs A Statement
Class A ITE is a category of all other ITE which satisfies the class A ITE limits but not
the class B ITE limits. The following warning shall be included in the instructions for use:
Warning
This is class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
2.1.4 Security Warnings

When using SFP transceiver, do not stare directly at the fiber bore when the switch is
in operation. Otherwise the laser may hurt your eyes.
 Do not attempt to conduct the operations which can damage the switch or which can
cause physical injury.
 Do not install, move or disclose the switch and its modules when the switch is in
operation.

Do not open the switch shell.

Digisol DG-GS4900SE Series Specifications

General

Brand	Digisol
Model	DG-GS4900SE Series
Category	Switch
Language	English