Digital Ally, Inc. | Installation Instructions
3-9
DVM-800 Installation Guide | 860-00185-00 Rev L
Go Back To Table of Contents
Option 2A and 2B: 12XC Camera & License Plate Camera
1. Attach the visor mount through the visor clip and attach front camera
to the mounting plate as shown below. Attach the front camera cable
(008-01442-00) to the DVM-800 CAM 1 input.
2. Determine a mounting location for the backup camera. Secure the
camera using the supplied hardware.
3. Attach the backup camera cable (008-01390-00) to the DVM-800
CAM 2 input. Leave slack in the cable as a service loop and for DVM
adjustment; then begin routing the cable to the rear of the vehicle.
4. Depending on your vehicle you may be able to route the cable down
the side of the headliner to a rear compartment of the vehicle.
Otherwise nd a suitable route on the oorboard of the vehicle.
5. To conceal the cable it may be necessary to loosen interior trim and
other components within the vehicle.
6. The cable connector for the Backup Camera should be routed to a rear
compartment of the vehicle such as the trunk of a car, to a location
within 3 feet of the rear license plate.
Mounting the License Plate Backup Camera (Option 2A)
7. Remove the top two screws holding the rear license plate to the
vehicle.
8. Use the screws to attach the backup camera bracket along the top
edge of the license plate.
Mounting the Mini Backup Camera (Option 2B)
9. Using the supplied self-drilling screws, mount the camera to an
appropriate location on the back of the vehicle where it will not
obscure any part of the license plate.
To Next Page
Loading...
Need help?
General
