Digital-Ally FirstVu HD - Page 17

Digital Ally, Inc. | Device Conguration using Mini Conguration Manager
4-1
FirstVu HD Operation Guide | 860-00177-00 Rev J
Go Back To Table of Contents
The FirstVu HD contains a default conguration and can be used immediately. It may be
recongured by activating the device using Digital Ally’s optional VuVault
®
back-oce
software (recommended), or the Mini Conguration Manager application which is part
of the Viewer installation software supplied on the internal drive of the FirstVu HD.
If you are not using VuVault
®
, follow the instructions in this section to congure and
activate your device using the stand-alone Mini Conguration Manager software.
4.1 Default Conguration
If the unit has never been activated, it will use the following default settings preset from
the factory.
• Central Standard Time (UTC-6)
• Daylight Saving: On
• Date format: mm/dd/yy
• Time format: 12 hour
• Record LED: On during record
• Pre-Event: Disabled
• Record Quality: High
• Record Size: 720p (1280 x 720)
• Audio Mode: Enabled for Event and Pre-Event recording
• Frames per Second: 30
• Vibrate Record: 1 Vibrate pulse every 10 seconds while recording
• Secure USB Port: Disabled
4.2 Mini Conguration Manager PC Software
The Mini Conguration Manager software is used to manage FirstVu HD settings as well
as activate a FirstVu HD device. Various congurable items can be adjusted to meet your
specic setting requirements.
The Mini Conguration Manager installation software is located on the FirstVu HD
internal drive which is accessed through the provided USB cable. Once the software is
installed, go to Start Menu > Programs > Digital Ally > Mini Conguration Manager to open
the application.
Section 4
Device Conguration using Mini Conguration Manager