12
english
13
STATUS
Indicates the overall system status by green, yellow and red colors.
PERMANENT GREEN LIGHT
The projector is turned on and in normal operation.
PERMANENT YELLOW LIGHT
The unit is in standby mode; no source(s) connected, or the source(s)
connected are inactive or switched off, thereby activating the power-save
function (DPMS). You may enable or disable the power save function in the
SET UP sub menu, DPMS on or off.
FLASHING YELLOW LIGHT
Please wait. The yellow light will flash a period after power cord is
connected (10-15 sec.), and a period after going to standby mode while
lamp is cooling down (approximately 45 sec.). The projector may not be
turned on again until the light has turned to permanent yellow.
FLASHING RED LIGHT
Projector is overheated. Turn off immediately! Check if air inlets are covered
or if ambient temperature is outside specifications. The projector can not be
restarted unless the power cord is disconnected and reconnected again.
If the projector continues to flash red, you will need to return the unit for
service.
LAMP 1, LAMP 2
Indicate the status of each lamp by green and red colors.
PERMANENT GREEN LIGHT
The lamp is on and in normal operation.
PERMANENT YELLOW
The lamp is ready and in standby mode
FLASHING YELLOW
Please wait. Lamp is cooling down.
PERMANENT RED LIGHT
Lamp life has expired or lamp is not igniting or lamp door is open. Please
change projection lamp immediately. Failing to change lamp may lead to
lamp explosion.
NO LIGHT
No lamp inserted / connected
LCD
The projector is fitted with a backlit LCD screen that reports system status.
You can navigate the LCD screen by using the arrow keys on the keypad.
INDICATORS
LCD
To Next Page
Loading...
