english
14
The remote control allows direct control of
projector settings. The remote control is
backlit for use in dark environments. It also has a datajack
that allows for wired connection to the projector.
When the wire is connected, the IR (infra-red) beam
and internal batteries are switched off.
POWER
Switches the projector between on and standby
modes.
TEST
Applies test images for set up and adjustment.
RESET
Press and hold for 2 seconds to reset settings to factory default.
BACKLIGHT
Switches the backlight on and off. The backlight will
switch off automatically after ten seconds.
LAMP DUAL
Press key 2 seconds to switch both lamps on.
LAMP 1
Press key 2 seconds to switch lamp 1 on or off. Observe wait time required
after switching off before switching on again. If lamp 2 is off, pressing this
key will switch lamp 1 off and lamp 2 on.
LAMP 2
Press key 2 seconds to switch lamp 2 on or off. Observe wait time required
after switching off before switching on again. If lamp 1 is off, pressing this
key will switch lamp 2 off and lamp 1 on.
CON
Press CON up or down to adjust image contrast electronically (not optical
iris).
BRIGHT
Press BRIGHT up or down to adjust image brightness electronically (not
lamp intensity).
COLOR
Press COLOR up or down to adjust color boost.
COLOR TEMP
Press UNCORR for uncorrected color temperature
TEMP
Press TEMP up or down to control the color temperature of the displayed
image.
D65
Press D65 to correct color temperature
SHUTTER
Toggles the mechanical shutter on and off.
REMOTE CONTROL
To Next Page
Loading...
Need help?
General
