31
DS6 User Manual
3. WARNING CODES
Warning codes (flashing codes)
Code Description
ArtDMX
ArtDmx stream is incoming from the WiFI module.
Works under Remote=WiFi only.
DMX
DMX stream is incoming from the XLR-5 pin on the DMX/RDM handle.
Works under Remote=DMX only.
“DEVICE ID ERROR”
Unable to communicate with DS6 frame or another device in a stack. The
device attempts to perform a new identification sequence.
“LOADING WIFI” or
“AWAITING WIFI”
WiFi settings are being acquired from the WiFi module. If there are
problems with communications this message may stay active in the WiFi
menu indefinitely.
“RESETTING WIFI” WiFi is being manually reset.
EL1 LED power delivery issues.
FW1 Firmware version mismatch in a stack.
OW##
Lamp Unit Communication. Various errors related to the calibration LUT
acquisition failure.
Handle FW!
DMX/RDM handle is in Bootloader mode, potentially due to unfinished
flashing sequence in the DS Upgrade Utility.
To Next Page
Loading...