Digital Watchdog VMAX A1 G4 DW-VA1G44 - Control

35 | VMAX A1 G4™ DVR
Address
Set the PTZ driver address of the connected camera. It should be the same as that of the
PTZ. (Not supported in UTC type protocol).
Control (The functions depend on the camera’s model and supported features)
When the PROGRAM button is selected, the OSD menu of the camera will appear on the
monitor. Set the PTZ’s speed, preset, tour, auto-pan, etc.
• Direction buttons: move the camera up, down, left, and
right.
• M (depends on PTZ model): Show/ hide the camera’s
OSD menu on the DVR monitor. Use the directional
arrows to navigate the menu options.
• Zoom, focus and iris: Control IN (+) and OUT (-) for
each function. (Depending on the camera’s model and
supported features).
• Speed: Change the PTZ speed (0~100). This sets the
speed at which the camera will move when controlled
from the DVR using the virtual joystick. Save the changes by clicking SET.
• Preset: Select the PTZ preset position that was created for the PTZ camera.
o Add: Move the camera’s position and zoom to the desired position. Select the
preset number using the button. Press ADD to save the new preset. (The
system supports preset the number of presets from 1 to 255.)
o Delete: remove the preset currently selected.
o Move: Enter a present number and press Move to move the camera to the preset
position of that number.
o To u r : Set the camera to move between preset positions
in order. The camera will keep running the tour until it
manually is disabled.
o Auto-pan: Set the camera to move 360° in one
direction. The camera will keep running the auto-pan
until it manually is disabled.
o Guard-tour: Set the camera to move between selected
presets in a set order and interval. The camera will keep
running the guard tour until it is manually disabled.
 Set: Set the time interval (in seconds) and select the preset position.
Add to sequence by clicking button. The preset will appear in the
sequence column showing the preset number and the set interval time.
 Delete: To remove a preset position from the sequence, select the
preset in the Sequence column and click the button.
 Move: Start the guard tour.
o Home: Set the camera to move to an original position memorized by the
camera.
In case the PTZ is directly connected to the rear panel of the DVR, the user can control
additional settings such as power, light, wiper and pump, etc. through the AUX control
button ( ).
2
1
3
4
5
6
7
8
9