D2-912 User Manual | 3
Preface
Copyright
All rights reserved. This manual is protected by copyright and distributed under licenses restricting its
use, replication and distribution. No part of this manual may be reproduced in any form without the
prior written consent from D2. The product described in this manual may include copyrighted software
of D2 (or other third parties). D2 (or other third parties) preserves the exclusive rights for copyrighted
software, such as the right to distribute or reproduce the copyrighted software. Accordingly, and to the
extent allowed by applicable law, any copyrighted software contained in the product described herein
shall not be distributed, modified, reverse engineered, or reproduced in any manner without the prior
written consent of D2 (or of other third parties).
All other product names, trademarks or logos mentioned herein are used for identification purposes
only, and may be the trademarks or registered trademarks of their respective owners.
Control Information
This device is in accordance with the requirements in Radio & Telecommunications Terminal Equipment
Directive 1995/5/EC.
This device complies with the requirements in EMC Electromagnetic Compatibility Directive
2004/108/EC and Low Voltage Directive 2006/95/EC.
FCC Statement
FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types D2 PAD has also
been tested against this SAR limit. The highest SAR value reported under this standard during product
certification for use at when properly worn on the body is 0.365W/kg. This device was tested for typical
body-worn operations with the back of the handset kept 0cm from the body. To maintain compliance
with FCC RF exposure requirements, use accessories that maintain a 1.5cm separation distance between
the user's body and the back of the handset. The use of belt clips, holsters and similar accessories
should not contain metallic components in its assembly. The use of accessories that do not satisfy these
requirements may not comply with FCC RF exposure requirements, and should be avoided.
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
To Next Page
Loading...
