Select the Pickup Type
In our example preset we use a single coil pickup, but want it to sound like a double coil humbucker.
With the Wah-Pickup LED lit, rotate the Parameter 4 knob until the display reads SC>Humb.This
makes a single coil sound like a Humbucker.
Turn the Compressor Off
We don’t use compression in our preset so, we need to turn the compressor off. To turn the
compressor off, do the following:
1. Press the EFFECT SELECT DOWN button. The Compression LED lights and the display
shows the current status of the Compressor.
2. If the Compressor is on, press the STATUS button until the red display reads off (Of).
Tu r n the Whammy™/IPS/Talker™ Off
We don’t want Whammy™, IPS, or Talker™ effects in this preset. To turn these effects off, do the
following:
1. Press the EFFECT SELECT DOWN button, and the Whammy/IPS/Talker™ LED is lit.
2. If the display indicates that either one of these effects is active, press the STATUS button until the
display reads off (Of).
Tu r n the Stompbox Modeling Off
To turn the Stompbox Modeling off for this preset, do the following:
1. Press the EFFECT SELECT DOWN button until the Stompbox LED is lit.
2. If the display indicates that it is active, press the STATUS button until the display reads off (Of).
Adjust the EQ
The EQ for both the Acoustic Model (Green Channel) and the Rectweed HyperModel™ ( Red
34
Tutorial
To Next Page
Loading...
Need help?
General
