5. Rotate the Parameter 3 knob to set the Reverb Decay to 15.
6. Rotate the Parameter 4 knob to set the Reverb Damping to 40.
7. Rotate the Parameter 5 knob to set the Reverb Level to 30.
Store the Preset
The last step, is to store our changes to a User Preset. If we changed presets or turned the GNX3
off without storing these settings, it would forget what we had done and revert back to the original
preset. To store the preset, do the following:
1. Press STORE.The first letter in the display begins to flash. Since this is an example preset, let’s
name the preset examplE.
2. Rotate the DATA WHEEL until the flashing character in the display is an E.
3. Press the RHYTHM button once and the second character begins to flash.
4. Rotate the DATA WHEEL again until the flashing character is an X.Continue using the Rhythm
button to select the character location and the Data Wheel to change the characters.
5. Once the Display reads exampLE,press STORE again.The numbers in the red numeric display are
flashing.
6. Rotate the DATA WHEEL to select 48 as the destination.
7. Press STORE once more to save the preset.
Congratulations! You have successfully created a Preset.
37
Tutorial
To Next Page
Loading...
Need help?
General
