DigiTech GNX3 User Manual

Analog Output Configuration
The GNX3’s analog outputs can be configured several different ways, giving you a variety of signal routing
possibilities for both recording and performing applications. The available analog output configurations
are:
mono (guitar processor and recorder output summed to mono) stereo (guitar processor and
recorder output in stereo),
g>l r>r (guitar left output, recorder right output), mono gtr (Mono
output, guitar processor only), and
ster gtr (Stereo output, guitar processor only).
When using either Mono or Stereo, both the GNX3’s guitar processing and the recorder’s outputs are
mixed together at the analog outputs. When Guitar
g>l r>r (guitar left output, recorder right output)
is selected, the GNX3’s guitar processing is summed to mono and sent to the left analog output while the
recorder’s output is summed to mono and sent to the right analog output. This is useful if you want to
run the GNX3 to a guitar amplifier setup (using the Left/Guitar output) while sending the recorder
output direct to a mixer (using the Right/Recorder output). When using either
mono gtr (Mono output,
guitar processor only), and
ster gtr (Stereo output, guitar processor only), only the GNX3’s guitar
processing is sent to the analog outputs and the recorder output is muted.
To select the analog output configuration, do the following:
1. Press the UTILITY button. The Utility button’s LED lights.
2. Using the MODE or DRUMS button, scroll to the left or right until
anlg out is displayed (Analog
Output Configuration setup menu). The display begins flashing between
anlg out and the selected
output configuration. Note:
stereo is the default set from the factory
3. Use the DATA WHEEL to change the output configuration.
4. Press the EXIT button to exit.
Ta rget System Setup
The GNX3 can be connected to any type of amplification system. However, the signal requirement
changes depending upon the type of amplification system. The Target System Setup optimizes the GNX3
for the type of amplification system it is used with.The procedure for selecting the Target System is as
follows:
1. Press the UTILITY button. The Utility button’s LED lights.
2. Using the MODE or DRUMS button, scroll to the left or right until
targ sys is displayed.
3. Rotate the DATA WHEEL to select the type of amplification system to be used.
4. Press EXIT to return to the GNX3 presets.
Volume Pedal Update
The GNX3 lets you select the Expression Pedal’s position to be updated, after changing presets, when it is
linked to the Volume Parameter. This feature lets you change presets and keep the volume level from the
previous preset, if the Expression Pedal controls the volume for both presets. If this feature is disabled,
new presets are set to the volume level value stored with the preset.The procedure for enabling or
disabling the Volume Pedal Update is as follows:
DIRECT For direct to console applications
INPT1X12 Instrument input of a 1x12 combo amp
FXLP1X12 Input into the effect return of a 1x12 combo
INPT2X12 Instrument input of a 2x12 combo amp
FXLP2X12 Input into the effect return of a 2x12 combo
INPT4X12 Instrument input of a 4x12 combo amp
FXLP4X12 Input into the effect return of a 4x12
combo
66
Other Functions

DigiTech GNX3 Specifications

General

Brand	DigiTech
Model	GNX3
Category	Music Pedal
Language	English