pressed the PLAY footswitch in relation to the tempo you are using for your loop. Lets say you were
recording a four second loop and you pressed the PLAY footswitch just a little late. No problem, with
Quantize enabled, the looper will automatically cut off the extra recording and give you a perfect four
second loop. Same goes for if you pressed the PLAY footswitch a little early. Quantize will push out the
length and make it four seconds. To enable the Quantize feature, follow these steps:
1. Start with the recorder stopped by pressing the STOP button.
2. Press the SETUP button until the GNX3’s main display reads:
quantize.
3. Use the DATA WHEEL to turn the Quantize feature on or off. Quantize only affects delay loops and
will not affect songs.
4. Press the EXIT button.
Now when you record the first loop, your loop will be accurately timed to the nearest quarter note even
if your footswitch timing was just a bit off.
NOTE: If the RECORD footswitch is pressed instead of the PLAY footswitch after recording
the first
61
Recorder
To Next Page
Loading...
Need help?
General
